Cold water water supply systems (max. 30°C) and hot water supply systems (max. 50°C) in multifamily housing, industrial facilities, public facilities, and metering stations. Install the water meter horizontally (H) with the counter upright. The rotating counter of the water meter facilitates direct readings from the dial. As a measurement system component, the water meter helps determine the water consumption characteristics of buildings. JS Impero water meter is available in the following versions: IP65 and IP68.

Metrological range (MID - R315)

  • Cold water H↑ R315




Product features

  • Preequipped for installation of: radio module for communication in the Wireless M-Bus,
    impulse module
  • Wide measuring range
  • Low starting rate
  • Double-sided rotor bearing
  • Removable measuring panel
  • Easy reading of the water meter counter
  • Counter mechanism with blockade against multiple rotating, at rotation angle more than 360°
  • Standard adaptation for installation of radio and impulse module
  • Readings reliability
  • Hermetic counter – IP68 on request *)
  • Special housing design with the connection for pressure measurement availableg


Technical data

JS 50 25 50 **270 / ***300 flange
JS 50-XX* 25 50 **270 / ***300 flange
JS 65 40 65 300 flange
JS 65-XX* 40 65 300 flange
JS 80 63 80 **300 /*** 350 flange
JS 80-XX* 63 80 **300 / ***350 flange
JS 100 100 100 **360 / ***350 flange
JS 100-XX* 100 100 **360 / ***350 flange

WWater meter housing with pressure measurement outlet available on request
*)Water meters designs – where
-XX stands for.
-NKOP – water meter adapted for installation of NK and NO transmitter (applies only to the IP65 version)
On request — housing with pressure measurement outlet (coupling with lockshield valve of the HASCO type: Z807/13/16x1.5)
**)Hermetic counter (IP68) available on request, pre equipped for radio transmitters - Wireless M-Bus standard
or NK transmitter with pulse range 10, 100 or 1000 (not applicable to NO and NKO)
***) On request (housing length according to ISO 4064)
****) Flange drilling: standard according to PN-EN 1092-2 (PN10), DIN 2532, DIN 2501 (PN10), BS4504 (PN10)

TA STRONA UŻYWA COOKIE. Korzystając ze strony wyrażasz zgodę na używanie cookie, zgodnie z aktualnymi ustawieniami przeglądarki. Korzystanie z naszego serwisu internetowego bez zmiany ustawień dotyczących cookies oznacza, że będą one zapisane w pamięci urządzenia. Więcej informacji można znaleźć
w naszej Polityce prywatności. W przeglądarce można zmienić ustawienia dotyczące cookies.
X Zamknij